Console overloaded with "getprotobynumber" when Murus is running

Murus
Post Reply
jamieshaw
Posts: 1
Joined: Tue Jan 09, 2018 2:03 pm

Console overloaded with "getprotobynumber" when Murus is running

Post by jamieshaw » Tue Jan 09, 2018 2:11 pm

I installed Murus a few days ago to great effect, however, a side effect I've noticed is that the Console is being overloaded with the following line, over and over again within seconds:

Code: Select all

getprotobynumber failed with result Not Found
As soon as PF is disabled, the error message goes away. I'm seeing this on two out of my three Macs, both if Murus is configured or reset to factory defaults (but PF is enabled). The third has no such issue when PF is enabled, and has never had Murus installed.

Not sure if this is an issue with PF on macOS or Murus' configuration of it — any ideas?

hany
Posts: 457
Joined: Wed Dec 10, 2014 5:20 pm

Re: Console overloaded with "getprotobynumber" when Murus is running

Post by hany » Sun Jan 14, 2018 2:31 pm

Hello,

this is a macOS 10.13 bug. We are all waiting for a fix.

Post Reply